|
DTC |
Item |
Contents of diagnosis |
Note |
|
11 |
Main switch |
Main switch of cruise control command switch is turned to OFF, and then the cruise control is released. |
This DTC is displayed without operating the main switch. |
|
12 |
Stop light & brake switch |
Stop light switch or brake switch is turned to ON, and then the cruise control is released. |
This DTC is displayed without depressing the brake pedal. |
|
13 |
Clutch switch |
Clutch switch is turned to ON, and then the cruise control is released. |
This DTC is displayed without depressing the clutch pedal. |
|
14 |
Neutral switch |
Neutral switch is turned to ON, and then the cruise control is released. |
This DTC is displayed without shifting to neutral position. |
|
15 |
Cancel switch |
Cancel switch is turned to ON, and then the cruise control is released. |
This DTC is displayed without operating the cancel switch. |
|
16 |
Ignition switch |
Ignition switch is turned to OFF, and then the cruise control is released. |
This DTC is displayed without operating the ignition switch. |
|
21 |
Cruise control switch malfunction when ignition switch is turned to ON |
When the ignition switch is turned to ON, each switch of cruise control command switch is already turned to ON. |
This DTC is displayed when the ignition switch is turned to ON without operating the cruise control switch. |
|
22 |
Vehicle speed variation is abnormal. |
Malfunction of vehicle speed signal variation is detected. |
|
|
24 |
Cruise control-related switch is abnormal. |
Short circuit of cruise control switch is detected during cruise driving. (Judged as a system without cruise control) |
|
|
25 |
Brake switch input circuit is abnormal. |
Malfunction of brake switch input circuit in ECM is detected. |
|
|
31 |
Engine speed signal |
• Abnormal increase of engine speed is detected. • Gear is placed in Neutral, 1st or Reverse position. |
|
|
32 |
Out of vehicle speed range of cruise control operation |
• Vehicle speed is out of the controllable range during cruise driving. • Set operation was performed at vehicle speed unavailable for setting. • RESUME operation was performed without memorized vehicle speed. |
This DTC is displayed, though the vehicle speed is increased to the speed available for cruise set and set operation was performed again. |
|
34 |
Prohibition when accelerator position is continued to be large. |
The vehicle has been driven at higher speed than set vehicle speed for an abnormally long time (approximately 10 minutes) during cruise driving. |
|
|
35 |
Prohibition when vehicle speed feedback is impossible. |
Set vehicle speed cannot be kept because of some reasons (steep uphill, parking brake, abnormal decrease of engine output, etc.) during cruise driving. |
|
|
41 |
VDC/TCS operation |
Vehicle dynamics control (VDC) or TCS is operated during cruise driving or cruise setting. |
|
|
43 |
ABS/VDC malfunction |
ABS or vehicle dynamics control (VDC) system malfunction is detected during cruise driving or cruise setting. |
|
|
61 |
Brake switch malfunction |
Malfunction of stop light & brake switch is detected. |
|
|
62 |
Neutral position switch malfunction |
Malfunction of neutral position switch is detected. |
|
|
63 |
Vehicle speed variation malfunction 1 |
Malfunction of vehicle speed signal variation is detected. |
|
|
64 |
Engine sensor related sensor malfunction 1 |
Malfunction related to engine is detected. |
|
|
65 |
Cruise control related switch malfunction 1 |
Malfunction of cruise control command switch is detected. (When the switch is continuously pressed ON for a long time (approximately two minutes), ON sticking is detected.) |
|
|
66 |
Cruise control computational malfunction |
Malfunction of cruise control calculation (microcomputer) is detected. |
|
