ENGINE (DIAGNOSTICS)(H4SO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P0134 O2 SENSOR CIRCUIT NO ACTIVITY DETECTED (BANK 1 SENSOR 1)

DTC DETECTING CONDITION:

Immediately at fault recognition

CAUTION:

After repairing or replacing the defective part, perform the Clear Memory Mode and Inspection Mode .

WIRING DIAGRAM:

STEPCHECKYESNO

1.CHECK HARNESS BETWEEN ECM AND FRONT OXYGEN (A/F) SENSOR CONNECTOR.

1) Turn the ignition switch to OFF.

2) Disconnect the connector from ECM and front oxygen (A/F) sensor connector.

3) Measure the resistance of harness between ECM and front oxygen (A/F) sensor connector.

Connector & terminal

(B135) No. 8 — (E23) No. 3:

(B135) No. 9 — (E23) No. 1:

Is the resistance less than 1 Ω?

Repair the harness and connector.

NOTE:

In this case, repair the following item:

• Open circuit of harness between ECM and front oxygen (A/F) sensor connector

• Poor contact in front oxygen (A/F) sensor connector

• Poor contact in ECM connector

2.CHECK POOR CONTACT.

Check poor contact of front oxygen (A/F) sensor connector.

Is there poor contact in front oxygen (A/F) sensor connector?

Repair the poor contact of the front oxygen (A/F) sensor connector.

Replace the front oxygen (A/F) sensor.