ENGINE (DIAGNOSTICS)(H4DOTC) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P0011 INTAKE CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE (BANK 1)

DTC DETECTING CONDITION:

Two consecutive driving cycles with fault

TROUBLE SYMPTOM:

• Engine stalls.

• Improper idling

CAUTION:

After repairing or replacing the defective part, perform the Clear Memory Mode and Inspection Mode .

STEP	CHECK	YES	NO
1.CHECK ANY OTHER DTC ON DISPLAY.	Is any other DTC displayed?	Check the appropriate DTC using the “List of Diagnostic Trouble Code (DTC)”.
2.CHECK CURRENT DATA. 1) Start the engine and let it idle. 2) Inspect the output of VVT advance angle amount and oil flow control solenoid valve duty using Subaru Select Monitor or general scan tool. NOTE: • Subaru Select Monitor For detailed operation procedure, refer to “READ CURRENT DATA FOR ENGINE”. • General scan tool For detailed operation procedure, refer to the general scan tool operation manual.	Is AVCS advance approximately 0 degrees, and the oil flow control solenoid valve duty output approx. 10%?	Check the following item and repair or replace if necessary. • Oil pipe (clog) • Oil flow control solenoid valve (clogged or dirty oil passages, spring settings) • Intake camshaft (dirt, damage of camshaft) • Timing belt (matching of timing mark)	A temporary malfunction. Perform the following, and clean the oil routing. Replace the engine oil and idle the engine for 5 minutes, and then replace the oil filter and engine oil.