ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting Failure > FUEL INJECTOR CIRCUIT

ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting Failure

FUEL INJECTOR CIRCUIT

CAUTION:

• Check or repair only faulty parts.

• After repairing or replacing the defective part, perform the Clear Memory Mode and Inspection Mode .

WIRING DIAGRAM:

STEP	CHECK	YES	NO
1.CHECK OPERATION OF EACH FUEL INJECTOR. While cranking the engine, check each fuel injector emits operating sound. Use a sound scope or attach a screwdriver to the injector and hear for this check.	Does the fuel injector emit operating sound?	Check the fuel pressure.
2.CHECK POWER SUPPLY TO EACH FUEL INJECTOR. 1) Turn the ignition switch to OFF. 2) Disconnect the connector from fuel injector. 3) Turn the ignition switch to ON. 4) Measure the power supply voltage between fuel injector terminal and engine ground. Connector & terminal #1 (E5) No. 2 (+) — Engine ground (−): #2 (E16) No. 2 (+) — Engine ground (−): #3 (E6) No. 2 (+) — Engine ground (−): #4 (E17) No. 2 (+) — Engine ground (−):	Is the voltage 10 V or more?		Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit of harness between main relay and fuel injector connector • Poor contact of main relay connector • Poor contact of coupling connector • Poor contact of fuel injector connector
3.CHECK HARNESS BETWEEN ECM AND FUEL INJECTOR CONNECTOR. 1) Disconnect the connectors from the ECM. 2) Measure the resistance of harness between ECM and fuel injector connector. Connector & terminal (B134) No. 17 — (E5) No. 1: (B134) No. 16 — (E16) No. 1: (B134) No. 27 — (E6) No. 1: (B134) No. 26 — (E17) No. 1:	Is the resistance less than 1 Ω?		Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit of harness between ECM and fuel injector connector • Poor contact of coupling connector
4.CHECK HARNESS BETWEEN ECM AND FUEL INJECTOR CONNECTOR. Measure the resistance of harness between ECM and fuel injector connector. Connector & terminal (B134) No. 16 — Chassis ground: (B134) No. 17 — Chassis ground: (B134) No. 26 — Chassis ground: (B134) No. 27 — Chassis ground:	Is the resistance less than 1 Ω?	Repair the ground short circuit of harness between ECM and fuel injector connector.
5.CHECK EACH FUEL INJECTOR. 1) Turn the ignition switch to OFF. 2) Measure the resistance between each fuel injector terminals. Terminals No. 1 — No. 2:	Is the resistance between 5 — 20 Ω?		Replace the faulty fuel injector.
6.CHECK POOR CONTACT. Check poor contact of ECM connector.	Is there poor contact in ECM connector?	Repair the poor contact of ECM connector.	Inspection using “General Diagnostic Table”.