1. Install the front oxygen (A/F) sensor and rear oxygen sensor to the front exhaust pipe. 
2. Install the front exhaust pipe to center exhaust pipe.
NOTE:
Use a new gasket.
Tightening torque:
40.0 N·m (4.1 kgf-m, 29.5 ft-lb)
3. Install the front and center exhaust pipe assembly to the vehicle.
4. Temporarily tighten the nuts which hold front exhaust pipe to cylinder heads.
NOTE:
Use a new gasket.
5. Tighten the bolt which holds the center exhaust pipe to exhaust pipe.
NOTE:
Use a new gasket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
6. Tighten the bolt which holds center exhaust pipe to hanger bracket.
Tightening torque:
35 N·m (3.6 kgf-m, 26.0 ft-lb)
7. Tighten the nuts which hold front exhaust pipe to cylinder heads.
NOTE:
Use a new gasket.
Tightening torque:
30 N·m (3.1 kgf-m, 22.4 ft-lb)
8. Install the under cover.
9. Lower the vehicle.
10. Install the clip fastening the harness and connect the following connectors.
(1) Front oxygen (A/F) sensor connector
(2) Rear oxygen sensor connector
|
(A) |
Front oxygen (A/F) sensor connector |
|
(B) |
Rear oxygen sensor connector |
|
(C) |
Clip |
11. Connect the battery ground cable to the battery.
