NOTE:
Use a new gasket.
1. Install the center exhaust pipe and temporarily tighten the bolt which holds center exhaust pipe to hanger bracket.
2. Temporarily tighten the bolt which holds the center pipe to transmission.
3. Connect the center exhaust pipe to turbocharger.
Tightening torque:
35 N·m (3.6 kgf-m, 26.0 ft-lb)
4. Install the center exhaust pipe to rear exhaust pipe.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
5. Connect the connector to rear oxygen sensor.
6. Secure clip on the crossmember.
7. Tighten the bolt which holds center exhaust pipe bracket to transmission.
Tightening torque:
30 N·m (3.1 kgf-m, 22.4 ft-lb)
8. Tighten the bolt which holds center exhaust pipe to hanger bracket.
Tightening torque:
35 N·m (3.6 kgf-m, 26.0 ft-lb)
9. Tighten the bolts which hold the intercooler bracket.
Tightening torque:
35 N·m (3.6 kgf-m, 26.0 ft-lb)
10. Lower the vehicle.
11. Position the turbocharger lower cover, and tighten the bolts which install the upper side of lower cover.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
12. Position the turbocharger upper cover, and tighten the bolts which install the upper side of upper cover.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
13. Lift up the vehicle.
14. Tighten the bolts which install the under side of turbocharger upper cover.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
15. Install the universal joint.
(1) Align the bolt hole on the long yoke side of universal joint with the notch at the serrated section of shaft end, and then insert the universal joint.
(2) Align the bolt hole on the short yoke side of universal joint with the notch on the serrated section of gearbox assembly. Lower the universal joint completely.
(3) Temporarily tighten the bolt of short yoke side. Raise the universal joint to make sure the bolt is properly passing through the notch at the serrated section.
(4) Tighten the long yoke side bolt, and also tighten the short yoke side bolt.
Tightening torque:
24 N·m (2.4 kgf-m, 17.4 ft-lb)
CAUTION:
• Make sure the universal joint bolts are tightened through the shaft serration notches.
• Do not apply excessively large tightening torque to the universal joint bolts. Doing so may lead to heavy steering wheel operation.
Standard clearance between gearbox and DOJ:
15 mm (0.59 in) or more
16. Install the under cover.
17. Lower the vehicle.
18. Install the intercooler bracket.
19. Install the intercooler. 
20. Align the center of the roll connector.
21. Install the collector cover.