1. Support the fuel tank with transmission jack and push the fuel tank harness into access hole with grommet.
2. Set the fuel tank and temporarily tighten the bolts of fuel tank bands.
WARNING:
A helper is required to perform this work.
3. Connect the 2 way valve hose (A) to the 2 way valve, and connect the canister hose (B) to the canister.
4. Connect the fuel filler hose and air vent hose.
5. Connect the fuel hoses, and secure with clips and quick connectors. 
6. Tighten the band mounting bolts.
Tightening torque:
33 N·m (3.4 kgf-m, 24.3 ft-lb)
7. Install the rear crossmember.
8. Connect the connector (A) to the fuel tank cord and plug the service hole with grommet (B).
9. Set the rear seat.
10. Connect the connector to the fuel pump relay.
