1. Install in the reverse order of removal. Observe the following instructions.
• Attaching the DOJ to the differential 
.
• Always tighten bushings with wheels in full contact with the ground and the vehicle at curb weight.
• Tighten the nut with the bolt head fixed in place when installing the adjusting bolt.
• When attaching the rear vehicle height sensor bracket to the lateral link and rear crossmember, tighten to the following torque values.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
CAUTION:
• Always use a new self-locking nut and DOJ circlip.
• Always use the ST so that DOJ splines do not damage the side oil seal.
| ST 28099PA090 | OIL SEAL PROTECTOR |
2. Inspect the wheel alignment and adjust if necessary.
3. Re-initialize the auto headlight beam leveler system. (Model with HID)