1. Disconnect the ground cable from the battery.

2. Lift up the vehicle, then remove the rear wheels.

3. Disconnect the connector from the rear vehicle height sensor. (HID model, right side only)

4. Remove the nuts that hold the lateral link and rear vehicle height sensor bracket. (HID model, right side only)

5. Remove bolt (A) and clip (B) fixing the rear vehicle height sensor bracket to the crossmember, then remove the rear vehicle height sensor assembly. (HID model, right side only)

6. Lift the crimped section of axle nut.

7. While applying the parking brake, remove the axle nut using a socket wrench.

CAUTION:

8. Return the parking brake lever and loosen the self-locking nut.

9. Remove the disc brake caliper from the back plate, and suspend it from strut using a piece of wire.

10. Remove the disc rotor from the hub.

NOTE:

11. Disconnect the parking brake cable end from the parking lever.

12. Disconnect the rear stabilizer from the rear lateral link.

13. Remove the bolts which secure trailing link assembly to the rear housing.

14. Remove the bolts which secure the lateral assembly to the rear housing.

15. Remove the rear ABS wheel speed sensor from the back plate.

16. Disengage the BJ assembly from the hub splines, and remove the rear drive shaft assembly.

If it is hard to remove, use the ST.

CAUTION:

17. Remove the bolts which secure the rear housing to strut, and separate the two.

1. Disconnect the ground cable from the battery.

2. Lift up the vehicle, and then remove the rear wheels.

3. Lift the crimped section of axle nut.

4. While applying the parking brake, remove the axle nut using a socket wrench.

CAUTION:

5. Return the parking brake lever and loosen the self-locking nut.

6. Remove the brake drum from hub.

7. If it is difficult to remove brake drum, remove the adjusting hole cover from the back plate, and then turn the adjusting screw using a flat tip screwdriver until the brake shoe separates from the drum.

NOTE:

8. Using a flare-nut wrench, disconnect the brake hose from the wheel cylinder. Place a cover on the brake pipe attachment hole of the wheel cylinder, to prevent entry of foreign particles.

9. Cover the end of the brake pipe with a vinyl sheet, etc. to prevent brake fluid from leaking out.

10. Disconnect the parking brake cable end from the parking brake lever.

11. Disconnect the rear stabilizer from the rear lateral link. Remove the bolts which secure trailing link assembly to the rear housing.

12. Remove the bolts which secure the lateral link assembly to the rear housing.

13. Remove the rear ABS wheel speed sensor from the back plate.

14. Disengage the BJ assembly from the housing splines, and remove the rear drive shaft assembly.

NOTE:

CAUTION:

15. Remove the bolts which secure the rear housing to strut, and separate the two.