1. Set the vehicle on a lift.
2. Loosen the wheel nuts.
3. Lift up the vehicle, then remove the rear wheels.
4. Release the parking brake.
5. Remove the brake drum from brake assembly.
NOTE:
• If it is difficult to remove the brake drum, remove the adjusting hole cover from back plate, then turn the adjuster assembly claws using a flat tip screwdriver until the brake shoe separates from the drum.
|
(1) |
Back plate |
|
(2) |
Wheel cylinder ASSY |
|
(3) |
Adjuster ASSY claws |
|
(4) |
Adjusting lever |
|
(5) |
Tightening direction |
|
(6) |
Push direction |
• If the brake drum is difficult to remove, drive it out by installing an 8-mm bolt into bolt hole in brake drum.
6. Hold the hold-down pin by securing rear of back plate with your hand.
|
(1) |
Hold-down cup |
|
(2) |
Hold-down pin |
7. Rotate the hold-down cup and remove from the hold-down pin.
8. Disconnect the lower shoe return spring from the brake shoe.
9. Remove each brake shoe along with adjuster from back plate.
CAUTION:
Be careful not to excessively bend the parking brake cable when removing the brake shoes.
|
(1) |
Wheel cylinder ASSY |
|
(2) |
Adjuster ASSY |
|
(3) |
Back plate |
|
(4) |
Lower shoe return spring |
|
(5) |
Parking lever |
|
(6) |
Brake shoe (Trailing) |
10. Disconnect the parking brake cable from the parking brake lever.
|
(1) |
Parking brake cable |
|
(2) |
Brake shoe (Trailing) |
|
(3) |
Parking brake lever |
11. Remove the upper shoe return spring and adjusting spring from the brake shoe.
|
(1) |
Upper shoe return spring |
|
(2) |
Adjusting spring |