1. Remove the transmission assembly from vehicle body. 
2. Pull out the torque converter clutch assembly.
3. Remove the input shaft.
4. Lift-up the lever on the rear side of transmission harness connector, and then disconnect it from the stay.
5. Disconnect the inhibitor switch from the stay.
6. Remove the oil charge pipe.
7. Remove the ATF cooler inlet and outlet pipes.
8. Separate the converter case from the transmission case.
9. Remove the seal pipe.
10. Remove the differential side retainers using ST.
NOTE:
Hold the differential case assembly by hand to avoid damaging the retainer mounting hole of the converter case.
| ST 499787000 | WRENCH ASSY |
11. Remove the differential assembly while being careful not to damage the attachment part of retainer.