1. Connect the inhibitor switch harness connector to the inhibitor switch.
2. Install the inhibitor switch assembly to the transmission case.
|
(A) |
Inhibitor switch ASSY |
3. Move the range select lever to the neutral position.
4. Using the ST, tighten the bolts of the inhibitor switch.
| ST 499267300 | STOPPER PIN |
Tightening torque:
3.4 N·m (0.35 kgf-m, 2.6 ft-lb)
|
(A) |
Inhibitor switch ASSY |
|
(B) |
Range select lever |
5. Install the select cable to the range select lever.
6. Install the plate assembly to the transmission.
Tightening torque:
T: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
|
(A) |
Select cable |
|
(B) |
Plate ASSY |
7. Install the washer and snap pin to the range select lever.
|
(A) |
Range select lever |
|
(B) |
Snap pin |
|
(C) |
Select cable |
|
(D) |
Washer |
8. Install the front and center exhaust pipe. (Non-turbo model)
9. Install the center exhaust pipe. (Turbo model)
10. Lower the vehicle.
11. Install the inhibitor switch connector to the stay.
12. Connect the inhibitor switch connector.
|
(A) |
Inhibitor switch connector |
13. Install the air intake chamber. (Non-turbo model)
14. Install the intercooler. (Turbo model)
15. Inspect the inhibitor switch.