1. Lift the vehicle.
2. Using the TORX ® BIT T70, remove the differential oil drain plug, and drain the gear oil.
|
(A) |
Drain plug |
3. Using the TORX ® BIT T70, tighten the differential oil drain plug.
NOTE:
Use a new gasket.
Tightening torque:
44 N·m (4.5 kgf-m, 33 ft-lb) (Aluminum gasket)
70 N·m (7.1 kgf-m, 52 ft-lb) (Copper gasket)
|
(A) |
Drain plug |
4. Remove the front and center exhaust pipes. (Non-turbo model) 
5. Separate the front drive shaft from the transmission.
6. Remove the differential side retainer oil seal using a screw driver wrapped with vinyl tape etc.
7. Using the ST, install the differential side retainer oil seal by lightly tapping with a hammer.
| ST 18675AA000 | DIFFERENTIAL SIDE OIL SEAL INSTALLER |
NOTE:
Apply oil to the oil seal lips.
8. Install the front drive shaft.
9. Install the front and center exhaust pipe. (Non-turbo model)
10. Lower the vehicle.
11. Pour gear oil through the gauge hole.