1. Install the oil pump to bracket.
(1) Place the oil pump bracket in a vise. Tighten the bushing using a 12.7 mm (1/2″) type 14- and 21- mm box wrench until it is in contact with the oil pump mounting surface.
CAUTION:
When securing the oil pump bracket in a vice, hold the oil pump bracket with the least possible force between two pieces of wood.
|
(1) |
Bushing |
|
(2) |
Nut |
|
(3) |
21 mm |
|
(4) |
14 mm |
|
(5) |
Bolt |
(2) Tighten the bolts which hold the oil pump to the bracket.
Tightening torque:
15.7 N·m (1.6 kgf-m, 11.6 ft-lb)
Tightening torque:
37.3 N·m (3.8 kgf-m, 27.5 ft-lb)
2. Attach the installation bolts of the power steering pump bracket.
3. Install pipe C and the suction hose to the oil pump.
Tightening torque:
Eye bolt
40 N·m (4.1 kgf-m, 29.5 ft-lb)
CAUTION:
Be careful when installing; If the hose is twisted it may come into contact with other parts.
|
(1) |
Suction hose |
|
(2) |
Pipe C |
4. Connect the power steering pump switch to the connector.
5. Install the V-belts to the oil pump.
6. Tighten the oil pump pulley nut to the specified torque.
Tightening torque:
52 N·m (5.3 kgf-m, 38.3 ft-lb)
7. Check the tension of the V-belt.
8. Tighten the belt tension bolt.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
9. Install the belt cover.
10. Connect the battery ground cable to the battery.
11. Fill with the specified power steering fluid.
CAUTION:
Never start the engine before filling with fluid; otherwise the vane pump may become seized.