CAUTION:
• When disconnecting/connecting hoses, do not apply an excessive force to them. After installing, check that no torsion or excessive tension applied to the hoses.
• Seal the disconnected hose with a plug or vinyl tape to prevent dirt from entering.
1. Disconnect the ground cable from the battery.
2. Using the refrigerant recovery system, discharge refrigerant. 
3. Remove the evaporator unit attaching bolts (A).
4. Remove the low-pressure hose attaching bolts (B).
5. Disconnect the low-pressure hose from evaporator unit.
6. Disconnect the low-pressure hose from compressor.
7. Remove the low-pressure hose from vehicle.
8. Remove the high-pressure hose attaching bolts (C).
9. Disconnect the high-pressure hose from compressor.
10. Disconnect the high-pressure hose from condenser.
11. Remove the high-pressure hose from vehicle.
12. Remove the high-pressure tube attaching bolt (D).
13. Remove the high-pressure tube from vehicle.
