CAUTION:
Turn off the light before adjusting the headlight beam level. If the light is necessary to check aiming, do not turn on for two minutes or more.
NOTE:
Before checking the headlight beam level, be sure of the following:
• The area around the headlight has not sustained any accident, damage or other type of deformation.
• Vehicle is parked on level ground.
• The inflation pressure of tires is correct.
• Vehicle’s fuel tank is fully filled.
1. Bounce the vehicle several times to normalize the suspension.
2. Make certain that someone is seated in the driver’s seat.
3. Measure the height of headlight center and the distance between the left and right valves.
4. Turn the headlights on and then adjust the low beam while displaying the beam on the screen.
NOTE:
• Set the headlight beam leveler switch to “0” position.
• Adjust the vertical beam level (A) first, then horizontal beam level (B) using a screwdriver.
LHD model is shown in the figure. The pattern is symmetrical for RHD model.
|
(A) |
Vehicle center |
(B) |
Bulb center marking |
|
W mm (in) |
h mm (in) at 3 m (10 ft) |
|
1,235 (48.6) |
30 (1.18) |