| CHECK AIRBAG MAIN HARNESS. |
|
1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more. 2) Disconnect the airbag resistor from the connector in the test harness P. 3) Remove the instrument panel lower cover, and disconnect the connector (AB21) from (AB26). 4) Disconnect the connector (AB3) from airbag control module, and connect the connector (1R) in the test harness R. 5) Measure resistance between connector (2R) in the test harness R and connector (2P) in the test harness P. Connector & terminal (2R) No. 3 — (2P) No. 1: (2R) No. 5 — (2P) No. 2: (2R) No. 9 — (3P) No. 3: (2R) No. 13 — (3P) No. 4: |
| QUESTION | |
|
Is the resistance less than 10 Ω? | |
| Yes | No |
|
|
Replace the airbag main harness along with body harness. |
