| CHECK AIRBAG MAIN HARNESS. |
|
1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more. 2) Disconnect the airbag resistor from the connector (3F) of test harness F. 3) Remove the glove box, and disconnect the connector (AB4) and (AB27). 4) Disconnect the connector (AB3) from airbag control module, and connect the connector (1R) in the test harness R. 5) Connect the battery ground terminal and turn the ignition switch to ON. (engine OFF) 6) Measure the voltage between connector (2R) in the test harness R and chassis ground. Connector & terminal (2R) No. 2 (+) — Chassis ground (−): (2R) No. 4 (+) — Chassis ground (−): |
| QUESTION | |
|
Is the voltage less than 1 V? | |
| Yes | No |
|
|
Replace the airbag main harness along with body harness. |
