| CHECK OUTPUT SIGNAL FROM TCM USING SUBARU SELECT MONITOR. |
|
1) Connect the connectors to TCM and transmission. 2) Lift up the vehicle and place it on rigid racks. NOTE: Raise all wheels off the floor. 3) Connect the Subaru Select Monitor to the data link connector. 4) Start the engine, and turn the Subaru Select Monitor power switch to ON. 5) Start the engine and warm-up the engine until the ATF temperature exceeds 80°C (176°F). NOTE: If the ambient temperature is below 0°C (32°F), drive the vehicle until the ATF reaches its operating temperature. 6) Read the data of high clutch duty solenoid using Subaru Select Monitor. NOTE: High clutch duty solenoid is indicated in “%”. 7) Shift the select lever to “D” range, and slowly increase vehicle speed to measure at 3rd or 4th. NOTE: The speed difference between front and rear wheels may illuminate the ABS warning light, but this does not indicate a malfunction. When AT control diagnosis is finished, perform the ABS or VDC clear memory of on-board diagnostics system. |
| QUESTION | |
|
Is the measured value 0%? | |
| Yes | No |
|
|
|