| CHECK HARNESSES BETWEEN ECM, TCM, VDCCM, STEERING ANGLE SENSOR AND DATA LINK CONNECTOR. |
|
1) Turn the ignition switch to OFF. 2) Disconnect the connectors from the ECM, TCM, VDCCM and the steering angle sensor. 3) Measure the resistance between ECM and TCM. Connector & terminal (B136) No. 35 — (B55) No. 17: (B136) No. 27 — (B55) No. 18: |
| QUESTION | |
|
Is the resistance 1 Ω or less? | |
| Yes | No |
|
|
Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit in harness between ECM and TCM connector • Poor contact of joint connector |
