AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble Code

DTC E8 FRONT SENSOR BUS LH COMMUNICATION ERROR

DTC DETECTING CONDITION:

• Open or short circuit in harness of front sensor bus (LH).

• Front sub sensor (LH) is faulty.

• Airbag control module is faulty.

CAUTION:

• Before diagnosing the airbag system, be sure to turn the ignition switch to OFF, disconnect the ground cable from battery, and wait 20 seconds or more before starting to work.

• When replacing the airbag module, seat belt pretensioner, lap seat belt pretensioner, roll connector, control module and sensor, reconnect each part and check that the warning light operates properly.

• When inspecting the airbag main harness, disconnect the airbag module connectors, seat belt pretensioners and lap seat belt pretensioner connectors of the driver’s and passenger’s seats for safety reasons.

WIRING DIAGRAM:

STEPCHECKYESNO

1.CHECK POOR CONTACT OF CONNECTORS.

Check for poor contact of the connectors (AB6, AB13) between the airbag control module and the front sub sensor (LH).

Is there poor contact?

Replace the airbag main harness along with body harness.

2.CHECK AIRBAG MAIN HARNESS (FRONT SENSOR BUS LH).

1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more.

2) Remove the instrument panel lower cover and disconnect the connectors (AB7) and (AB2).

3) Remove the console front panel and disconnect the connectors (AB9) and (AB10).

4) Disconnect the connectors (AB17, AB6, AB18) from airbag control module.

5) Connect the connector (1AG) in the test harness AG to the connectors (AB17, AB6, AB18).

NOTE:

For model without side airbag, connect test harness AH between the connectors (AB6, AB17, AB18) and (1AG).

6) Disconnect the front sub sensor (LH), and then connect the connector (1H) in the test harness H to connector (AB13).

7) Measure the resistance between connector (4AG) in the test harness AG and connector (3H) in the test harness H.

Connector & terminal

(4AG) No. 7 — (3H) No. 5:

(4AG) No. 9 — (3H) No. 6:

Is the resistance less than 10 Ω?

Replace the airbag main harness along with body harness.

3.CHECK AIRBAG MAIN HARNESS (FRONT SENSOR BUS LH).

Measure the resistance between connector (4AG) in the test harness AG and chassis ground, and the resistance between connector (4AG) terminals in the test harness AG.

Connector & terminal

(4AG) No. 7 — Chassis ground:

(4AG) No. 9 — Chassis ground:

(4AG) No. 7 — (4AG) No. 9:

Is the resistance 1 MΩ or more?

Replace the airbag main harness along with body harness.

4.CHECK AIRBAG CONTROL MODULE.

1) Connect all connectors.

2) Clear the memory.

3) Perform the Inspection Mode.

4) Read the DTC.

Is the same DTC displayed?

Replace the front sub sensor (LH). Replace the airbag control module if not operating normally even after replacing the sensor.

5.CHECK FOR ANY OTHER DTC ON DISPLAY.

Is any other DTC displayed?

Check DTC using “List of Diagnostic Trouble Code”.

Finish the diagnosis.