LAN SYSTEM (DIAGNOSTICS) > User Customizing

1. On «Main Menu» display, select {Each System Check}.

2. On «System Selection Menu» display, select {Integ. unit mode}.

3. On «Integ. unit mode failure diag» display, select {ECM customizing}.

4. Change the setting with UP/DOWN key and set with the [OK] key.

• List of User Customizing item

Data	Initial setting value	Customize setting	Remarks
Off delay time	Normal		Delay time below can be selected by setting.
			After door closed	After keyless unlock
		OFF	0 second	0 second
		Short	3 seconds	10 seconds
		Normal	5 seconds	20 seconds
		Long	8 seconds	30 seconds
Auto lock time	30 seconds	0 — 60 sec.	Workable when Auto locking is set to “ON” and Automatic locking setup is “ON”. Time can be changed by 10 seconds: 0 (OFF) — 60 (maximum).
Rr defogger op. mode	Normal	Normal	Automatically stops in 15 minutes after switch is turned to ON.
Rr defogger op. mode	Normal	Continuous	Repeats active condition for 15 minutes and inactive condition for 2 minutes until switch is turned to OFF.
Wiper deicer op. mode	Normal	Normal	Automatically stops in 15 minutes after switch is turned to ON.
Wiper deicer op. mode	Normal	Continuous	Repeats active condition for 15 minutes and inactive condition for 2 minutes until switch is turned to OFF.
Lockout prevention	ON	ON	Lockout prevention in active condition. (The function does not operate if safety knob is locked by hand.)
Lockout prevention	ON	OFF	Lockout prevention in inactive condition
Automatic locking setup	ON	ON	Workable when Automatic locking setup is “ON” Automatic locking operates.
Automatic locking setup	ON	OFF	Automatic locking does not operate.
Auto locking	ON	ON	Vehicle is controlled in auto locking equipped mode.
Auto locking	ON	OFF	Automatically set depending on the part number of unit, destination and whether double lock is equipped or not. These cannot be changed.
Door open warning (prevention of battery run-out)	OFF	ON	If detecting door open for 30 minutes, room light, and key ring illumination that are related to doors are turned off to prevent battery run-out.
Door open warning (prevention of battery run-out)	OFF	OFF	Room light, key illumination and door warning light is not turned off.
Select unlock switch	ALL	Selection	Setting change is possible only for LHD model with keyless access.
Select unlock switch	ALL	ALL

5. After setting, make sure that the setting changed in the {Current Data Display & Save} is same as vehicle equipment.

CAUTION:

• The above settings must match the actual vehicle equipment.

• Do not change settings except for setting above while setting the functions.

• Be sure not to change Factory or Market setting except when installing a new body integrated unit.

NOTE:

For detailed operation procedures, refer to “PC application help for Subaru Select Monitor”.