ENGINE (DIAGNOSTICS)(H4DOTC) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P2122 THROTTLE/PEDAL POSITION SENSOR/SWITCH “D” CIRCUIT LOW INPUT

DTC DETECTING CONDITION:

Immediately at fault recognition

TROUBLE SYMPTOM:

• Improper idling

• Poor driving performance

CAUTION:

After repairing or replacing the defective part, perform the Clear Memory Mode and Inspection Mode .

WIRING DIAGRAM:

STEPCHECKYESNO

1.CHECK HARNESS BETWEEN ECM AND ACCELERATOR PEDAL POSITION SENSOR.

1) Turn the ignition switch to OFF.

2) Disconnect the connector from the ECM and accelerator pedal position sensor.

3) Measure the resistance between ECM and chassis ground.

Connector & terminal

(B135) No. 21 — Chassis ground:

(B135) No. 23 — Chassis ground:

(B135) No. 23 — (B136) No. 6:

Is the resistance 1 MΩ or more?

Repair the short circuit to ground in harness between ECM and accelerator pedal position sensor connector.

2.CHECK SHORT CIRCUIT INSIDE THE ECM.

1) Connect the ECM to connector.

2) Measure the resistance between accelerator pedal position sensor connector and chassis ground.

Connector & terminal

(B315) No. 6 — Chassis ground:

Is the resistance 1 MΩ or more?

Replace the accelerator pedal.

Repair the short circuit to ground in harness between ECM and accelerator pedal position sensor connector. Replace the ECM if defective.