ENGINE (DIAGNOSTICS)(H4DOTC) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P0132 O2 SENSOR CIRCUIT HIGH VOLTAGE (BANK 1 SENSOR 1)

DTC DETECTING CONDITION:

Immediately at fault recognition

CAUTION:

After repairing or replacing the defective part, perform the Clear Memory Mode and Inspection Mode .

WIRING DIAGRAM:

STEPCHECKYESNO

1.CHECK FRONT OXYGEN (A/F) SENSOR CONNECTOR AND COUPLING CONNECTOR.

Has water entered the connector?

Completely remove any water inside.

2.CHECK HARNESS BETWEEN ECM AND FRONT OXYGEN (A/F) SENSOR CONNECTOR.

1) Turn the ignition switch to OFF.

2) Disconnect the connector from front oxygen (A/F) sensor.

3) Turn the ignition switch to ON.

4) Measure the voltage between ECM and chassis ground.

Connector & terminal

(B135) No. 9 (+) — Chassis ground (−):

(B135) No. 8 (+) — Chassis ground (−):

Is the voltage 8 V or more?

Repair the short circuit to power in the harness between the ECM and front oxygen (A/F) sensor connector.

Replace the front oxygen (A/F) sensor.