ENGINE (DIAGNOSTICS)(H4DOTC DIESEL) > Clear Memory Mode

OPERATION

NOTE:

When Clear Memory Mode is performed in OBD mode of Subaru Select Monitor, only DTCs are cleared.

1. SUBARU SELECT MONITOR (NORMAL MODE)

1. On «Main Menu» display, select {Each System Check}.

2. On «System Selection Menu» display, select {Engine Control System}.

3. Click the [OK] button after the information of engine type has been displayed.

4. On «Engine Diagnosis» display, select {Clearing Memory}.

5. When the “Clear Memory?” is shown on the screen, click the [Yes] button.

6. When “Done” and “Turn off the ignition switch.” are shown on the display screen, turn the ignition switch to OFF.

NOTE:

• When turning the ignition switch to ON after Clear Memory Mode, wait for at least 10 seconds since step 6) has been completed.

• For detailed operation procedures, refer to “PC application help for Subaru Select Monitor”.

2. SUBARU SELECT MONITOR (OBD MODE)

1. On the «Main Menu» display screen, select the {Each System Check}.

2. On the «System Selection Menu» display screen, select the {Engine Control System}.

3. Click the [OK] button after the information of engine type has been displayed.

4. On the «Engine Diagnosis» display screen, select the {OBD System}.

5. On the «OBD Menu» display screen, select the {Clear Diagnostic Code?}.

6. When the “Clear Diagnostic Code?” is shown on the screen, click the [Yes] button.

7. When “Done” and “Turn ignition switch to OFF” is shown on the display screen, turn the ignition switch to OFF.

NOTE:

For detailed operation procedure, refer to the “PC application help for Subaru Select Monitor”.

3. GENERAL SCAN TOOL

For procedures clearing memory using the general scan tool, refer to the general scan tool operation manual.