1.CHECK ACCELERATOR PEDAL POSITION SENSOR OUTPUT.
1) Turn the ignition switch to ON.
2) Measure the voltage between ECM connector and chassis ground.
Connector & terminal
Main accelerator pedal position sensor signal
(B135) No. 39 (+) — Chassis ground (−):
Sub accelerator pedal position sensor signal
(B135) No. 28 (+) — Chassis ground (−):
|
Is the difference between the measured value of main accelerator pedal position sensor signal and the measured value of sub accelerator pedal position sensor signal 0 V?
|
|
|
2.CHECK ACCELERATOR PEDAL POSITION SENSOR OUTPUT.
1) Measure the voltage between accelerator pedal position sensor connector and chassis ground.
Connector & terminal
(B315) No. 6 (+) — Chassis ground (−):
(B315) No. 3 (+) — Chassis ground (−):
|
Is the difference between the measured value of main accelerator pedal position sensor signal and the measured value of sub accelerator pedal position sensor signal 0 V?
|
Replace the accelerator pedal. 
|
Repair the harness and connector.
NOTE:
In this case, repair the following item:
• Open circuit of harness between ECM connector and accelerator pedal position sensor connector.
• Short circuit to ground in harness between ECM connector and accelerator pedal position sensor connector
|
3.CHECK HARNESS BETWEEN ECM AND ACCELERATOR PEDAL POSITION SENSOR CONNECTOR.
Check the resistance of harness between the accelerator pedal position sensor connector and chassis ground.
Connector & terminal
(B315) No. 5 — Chassis ground:
(B315) No. 2 — Chassis ground:
|
Is the resistance less than 5 Ω?
|
Repair the poor contact of ECM connector.
|
Repair the harness and connector.
NOTE:
In this case, repair the following item:
• Open circuit of harness between ECM connector and accelerator pedal position sensor connector.
• Open circuit of harness between ECM connector and engine ground
• Poor contact of coupling connector
|
