Install in the reverse order of removal while being careful of the following.
• Make sure the sealing portion is free from fuel or foreign matter before installation.
• Install with the protrusion (A) of gasket aimed at the front side of the vehicle.
• Insert the protrusion (B) of gasket to the upper plate. (3 places)
• Align the protrusion (C) of fuel pump assembly with the cutout on the upper plate.
• Tighten the nuts to the specified torque in the order as shown in the figure.
NOTE:
Use a new gasket and retainer.
Tightening torque:
4.4 N·m (0.4 kgf-m, 3.2 ft-lb)
