CAUTION:
The radiator is pressurized. Wait until engine cools down before working on the radiator.
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Lift up the vehicle.
4. Remove the under cover.
5. Remove the heat shield cover from radiator. (Models without ATF warmer)
6. Drain engine coolant completely.
7. Disconnect the connectors of main fan motor (A) and sub fan motor (B).
8. Disconnect the radiator outlet hose from thermostat cover.
9. Disconnect the ATF cooler hoses from ATF pipes. (Models without ATF warmer)
NOTE:
Plug the ATF pipe to prevent ATF from leaking.
10. Lower the vehicle.
11. Disconnect the over flow hose.
12. Remove the reservoir tank.
13. Remove the air intake duct.
14. Disconnect the radiator inlet hoses from the engine.
15. Remove the radiator upper brackets.
16. Lift the radiator up and away from vehicle.