1. Assemble the center exhaust pipe (front) and center exhaust pipe (rear).
NOTE:
Use a new gasket.
Tightening torque:
42.5 N·m (4.3 kgf-m, 31.3 ft-lb)
2. Set the turbo charger lower cover, and temporarily tighten the bolt holding the lower side of the turbo charger lower cover.
3. Install the center exhaust pipe and temporarily tighten the bolt which holds center exhaust pipe to hanger bracket.
4. Temporarily tighten the bolt which holds the center exhaust pipe to the transmission.
5. Connect the center exhaust pipe along with the turbo charger cover stay (A) to the turbocharger.
NOTE:
Use a new gasket.
Tightening torque:
42.5 N·m (4.3 kgf-m, 31.3 ft-lb)
6. Install the center exhaust pipe to rear exhaust pipe.
NOTE:
Use a new gasket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
7. Connect the connector to the rear oxygen sensor, and hold the rear oxygen sensor harness with clip (A).
• AT model
• MT model
8. Tighten the bolt which holds center exhaust pipe bracket to transmission.
Tightening torque:
30 N·m (3.1 kgf-m, 22.1 ft-lb)
9. Tighten the bolt which holds center exhaust pipe to hanger bracket.
Tightening torque:
35 N·m (3.6 kgf-m, 25.8 ft-lb)
10. Lower the vehicle.
11. Attach the bolts which hold the upper side of the turbo charger lower cover.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
12. Attach the turbo charger upper cover.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
13. Lift up the vehicle.
14. Tighten the bolts which hold the lower side of the turbo charger lower cover.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
15. Install the universal joint. (RHD model) 
16. Lower the vehicle.
17. Install the intercooler.
18. Connect the ground cable to the battery.
19. Install the collector cover.