CAUTION:
When replacing the turbocharger, check the filter part of union screw for clogging. 
1. Install the turbocharger stay.
Tightening torque:
T1: 33 N·m (3.4 kgf-m, 24.3 ft-lb)
T2: 42.5 N·m (4.3 kgf-m, 31.3 ft-lb)
|
(A) |
To cylinder head RH |
|
(B) |
To cylinder block RH |
2. Connect the oil outlet hose to the oil outlet pipe.
3. Connect the engine coolant hoses to the water pipe.
4. Install the oil inlet pipe to the turbocharger.
CAUTION:
In order to prevent damaging the oil pipe on the cylinder head side, fix the section (a) shown in the figure when tightening the oil inlet pipe flare nut, and avoid the part from rotating together while tightening the nut.
Tightening torque:
T1: 5 N·m (0.5 kgf-m, 3.7 ft-lb)
T2: 16 N·m (1.6 kgf-m, 11.8 ft-lb)
T3: 20 N·m (2.0 kgf-m, 14.5 ft-lb)
5. Connect the air control hose (A), and install the turbocharger to the intake duct.
Tightening torque:
3 N·m (0.3 kgf-m, 2.2 ft-lb)
6. Connect the engine coolant hose which is connected to the coolant filler tank.
7. Install the joint pipe to turbocharger.
NOTE:
Replace the gasket with a new part.
Tightening torque:
42.5 N·m (4.3 kgf-m, 31.3 ft-lb)
8. Lift up the vehicle.
9. Install the center exhaust pipe.
10. Lower the vehicle.
11. Install the intercooler.
12. Fill engine coolant.
13. Connect the ground cable to the battery.
14. Install the collector cover.