CAUTION:
The radiator is pressurized. Wait until engine cools down before working on the radiator.
1. Set the vehicle on a lift.
2. Remove the collector cover.
3. Disconnect the ground cable from battery.
4. Lift up the vehicle.
5. Remove the under cover.
6. Remove the heat shield cover from radiator. (AT model)
7. Drain engine coolant completely.
8. Disconnect the connectors of main fan motor (A) and sub fan motor (B).
9. Disconnect the radiator outlet hose from thermostat cover.
10. Disconnect the ATF cooler hoses from ATF pipes. (AT model)
NOTE:
Plug the ATF pipe to prevent ATF from leaking.
11. Lower the vehicle.
12. Remove the air intake duct.
13. Remove the reservoir tank.
14. Disconnect the radiator inlet hose from the radiator.
15. Disconnect the two coolant filler tank hoses from the radiator.
16. Remove the radiator upper brackets.
17. Move the radiator to the left while lifting it upward.
18. Lift the radiator up and away from vehicle.