|
(1) |
Connecting rod |
(4) |
Piston pin |
(7) |
Second ring |
|
(2) |
Connecting rod bearing |
(5) |
Snap ring |
(8) |
Top ring |
|
(3) |
Piston |
(6) |
Oil ring |
1. Apply oil to the surface of the connecting rod bearing. Attach the connecting rod bearing to the connecting rod.
2. Join the connecting rod and piston.
NOTE:
Position each connecting rod with the marked side facing forward.
3. Apply oil to the piston pin, and attach the piston pin.
4. Using snap ring pliers, attach the snap ring.
5. Attach the oil ring by hand. Install the second ring and top ring using piston ring expander.
6. Apply liquid gasket to the mating surfaces of the oil separator cover, and install the oil separator cover.
NOTE:
• Install within 5 min. after applying liquid gasket.
• Use new oil separator cover.
Liquid gasket:
Mating surface
THREE BOND 1217G (Part No. K0877Y0100) or equivalent
Liquid gasket applying diameter:
4.5 ±0.5 mm (0.1772±0.0197 in)
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
|
(A) |
5.5 mm (0.2165 in) |
(B) |
6.0 mm (0.2362 in) |