Install in the reverse order of removal while being careful of the following.
• Make sure the sealing portion is free from fuel or foreign matter before installation.
• Align protrusion (A) of the gasket to the position shown in the following figure.
• Align protrusion (B) of the fuel sub level sensor to the cut out in the fuel sub level sensor upper plate.
• Tighten the nuts and bolts to the specified torque in the order as shown in the figure.
NOTE:
Use a new gasket and retainer.
Tightening torque:
4.4 N·m (0.4 kgf-m, 3.2 ft-lb)
|
(A) |
Gasket protrusion |
(B) |
Fuel sub level sensor protrusion |
(C) |
Front side of vehicle |
