1. Place alignment marks on the shaft and outer race.
2. Remove the PTJ boot band and boot.
CAUTION:
Be careful not to damage the boot.
3. Remove the snap ring from the PTJ outer race.
4. Remove the PTJ outer race from the shaft assembly.
5. Wipe off grease.
CAUTION:
The grease is a special type of grease. Do not mix with other grease.
6. Place alignment marks on the roller kit and trunnion.
7. Remove the roller kit from trunnion.
CAUTION:
Be careful with the roller kit position.
8. Place alignment marks on the trunnion and shaft.
9. Remove the snap ring and trunnion.
CAUTION:
Be sure to wrap shaft splines with vinyl tape to protect the boot from scratches.
10. Remove the PTJ boot.
11. Remove the O-ring in the shaft boot groove.
NOTE:
The EBJ is a non-disassembly part, so the axle disassembly stops here.