1. Place the disc cover between housing and front hub unit, and tighten the four bolts.
Tightening torque:
65 N·m (6.6 kgf-m, 47.9 ft-lb)
|
(A) |
Housing |
2. Install the front drive shaft. 
3. Tighten the axle nut temporarily.
4. Install the disc rotor to hub.
5. Install the disc brake caliper on the housing.
Tightening torque:
80 N·m (8.2 kgf-m, 59 ft-lb)
6. While depressing the brake pedal, tighten a new axle nut to the specified torque and lock it securely.
Tightening torque:
220 N·m (22.4 kgf-m, 162.3 ft-lb)
CAUTION:
• Do not install wheel and let it touch the ground before tightening the axle nut. Failure to follow this rule may damage the axle bearing.
• Do not overtighten the nuts as this may damage the axle bearing.
7. After tightening the axle nut, lock it securely.
8. Install the wheel.
Tightening torque:
100 N·m (10.2 kgf-m, 73.8 ft-lb)