1. Disconnect the ground cable from battery.
2. Use compressed air to remove moisture and dust around the VDCCM&H/U.
NOTE:
If the terminals become dirty, it may cause improper contact.
3. Lift the lock lever and disconnect the VDCCM&H/U connector.
CAUTION:
Do not pull on the harness when disconnecting the connector.
4. Disconnect the brake pipes from the VDCCM&H/U.
5. Wrap the brake pipe with a vinyl bag so as not to spill the brake fluid on the vehicle body.
CAUTION:
If brake fluid is spilled on the vehicle body, wash it off immediately with water and wipe clean.
6. Remove the nuts and remove the VDCCM&H/U.
CAUTION:
• Do not drop or bump the VDCCM&H/U.
• Do not turn the VDCCM&H/U upside down or place it sideways for storage.
• Be careful not to let foreign matter enter the VDCCM&H/U.
• Be careful that no water enters the connectors.
7. Remove the VDCCM&H/U bracket.