CAUTION:
Be sure the lining surface is free from brake fluid and grease.
1. Apply brake grease to the following locations.
Brake grease:
Brake Grease (Part No. 003602002)
• Six contact surfaces of the brake shoe rim and back plate gasket
• Contact surface of the brake shoe and the anchor pin
• Contact surface of the parking brake lever and strut
• Contact surface of the brake shoe and the adjuster
• Contact surface of the brake shoe and strut
• Contact surface of lever and brake shoe
2. Install the wave washer and lever to the secondary side brake shoe pin, and lock the retainer securely.
3. Install the parking brake cable to the lever.
4. Install the adjuster and adjusting spring to the brake shoe.
NOTE:
Install the adjuster with screw section in the direction shown below.
|
(1) |
For left wheels, facing the front side of vehicle, for right wheels, facing the rear side of vehicle |
5. Check that the parking brake cable does not fall from the cable guide.
6. Install the brake shoes to the back plate with shoe hold pins, brake shoe springs, and brake shoe cups.
7. Install the strut and strut spring to the brake shoes.
NOTE:
Install the strut springs on the front side of the vehicle.
8. Install the return springs; first the primary side (blue) then the secondary side (yellow).
9. Install the brake disc rotor and the brake caliper.
10. Install the brake hose bracket.
Tightening torque:
11. Adjust the parking brake.
12. If new brake shoes are replaced, drive the vehicle to break-in the parking brake lining.
(1) Drive the vehicle at about 35 km/h (22 MPH).
(2) With the parking brake lever button pushed in, pull the parking brake lever gently.
(3) Drive the vehicle for about 200 m (0.12 mile) in this condition.
(4) Wait 5 to 10 minutes for the parking brake to cool down. Repeat steps (1) through (3) again.
(5) After breaking-in, re-adjust the parking brakes.