1. Install the joint to the transmission and secure with a spring pin.
|
(A) |
Joint |
|
(B) |
Spring pin |
2. Insert the gear shift lever from the room side.
NOTE:
Insert the rod and the stay, and then temporarily set them onto the transmission mount.
3. Lift up the vehicle.
4. Mount the cushion rubber on the vehicle body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
|
(A) |
Stay |
|
(B) |
Cushion rubber |
5. Using new self-locking nuts, connect the rod to the joint.
Tightening torque:
12 N·m (1.2 kgf-m, 8.9 ft-lb)
|
(A) |
Stay |
|
(B) |
Rod |
6. Using new self-locking nuts, connect the stay to the transmission bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
|
(A) |
Stay |
|
(B) |
Transmission bracket |
7. Install the heat shield cover.
8. Install the rear exhaust pipe and muffler.
• Non-turbo model
• Turbo model
9. Install the plate COMPL to the body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
(1) Set the plate COMPL to the vehicle.
(2) Temporarily tighten the bolt (A).
(3) Tighten the bolt (B).
(4) Tighten the bolt (A).
(5) Tighten the bolts (C) and (D).
10. Install the harness clamp to the plate.
11. Install the boot and insulator assembly, and secure with a clamp.
12. Install the console cover and console box.
13. Install the console front panel and console boot.
14. Install the gear shift knob.
15. Make sure the gears can be shifted accurately into each gear.
1. Install the gear shift lever assembly.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
2. Lift up the vehicle.
3. Install the cable cover assembly.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
4. Connect the MT gear shift cable and MT gear select cable.
CAUTION:
Be careful not to deform the cable inner.
|
(A) |
MT gear shift cable |
|
(B) |
MT gear select cable |
5. Install the cable cover plate.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
6. Install the heat shield cover.
7. Install the exhaust pipe (front).
8. Lower the vehicle.
9. Install the console front panel.
10. Install the console box.
11. Install the gear shift knob.
12. Make sure the gears can be shifted accurately into each gear. Adjust the MT gear select lever, if the gears cannot be shifted correctly.