1. Set the vehicle on a lift.
2. Shift the select lever to “N” range.
3. Lift up the vehicle.
4. Remove the rear exhaust pipe and muffler.
• Non-turbo model
• Turbo model
5. Remove the heat shield cover.
6. Loosen the adjusting nuts on both sides.
|
(A) |
Adjusting nut A |
|
(B) |
Adjusting nut B |
7. Turn adjusting nut B until it lightly touches the connector.
|
(A) |
Forward side |
|
(B) |
Select lever |
|
(C) |
Connector |
|
(D) |
Adjusting nut B |
|
(E) |
Contact point |
|
(F) |
Adjusting nut A |
8. Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
|
(A) |
Adjusting nut A |
|
(B) |
Adjusting nut B |
9. After the completion of adjustment, confirm that the select lever operates normally at all ranges.
10. Install in the reverse order of removal.