1. Remove the transmission assembly from vehicle body. 
2. Pull out the torque converter clutch assembly.
3. Remove the input shaft.
4. Lift up the lever on the rear side of transmission harness connector, and then disconnect it from the stay.
5. Disconnect the inhibitor switch from the stay.
6. Remove the oil charge pipe.
7. Remove the ATF inlet and outlet pipes.
8. Separate the converter case from the transmission case.
9. Remove the seal pipe.
10. Remove the differential side retainers using ST.
| ST 18630AA010 | WRENCH COMPL RETAINER |
NOTE:
• ST WRENCH ASSY (499787000) can also be used.
• Hold the differential case assembly by hand to avoid damaging the retainer mounting hole of the converter case.
11. Remove the front differential assembly while being careful not to damage the attachment part of the retainer.