1. Remove the transmission assembly from vehicle body. 
2. Pull out the torque converter clutch assembly.
3. Remove the input shaft.
4. Lift up the lever on the rear side of transmission harness connector, and then disconnect it from the stay.
5. Disconnect the inhibitor switch connector from the stay.
|
(A) |
Transmission harness connectors |
|
(B) |
Inhibitor switch connector |
6. Remove the air breather hose.
7. Remove the oil charge pipe.
8. Remove the ATF inlet and outlet pipes.
9. Remove the converter case alignment bolt, and then separate the transmission case and converter case by lightly tapping with a plastic hammer.
NOTE:
• Be careful not to damage the oil seal and bushing in the converter case with the oil pump cover.
• Be careful not to loosen the rubber seal.
10. Remove the seal pipe.
|
(A) |
Seal pipe |
11. Remove the front differential assembly.
12. Remove the oil seal from converter case.