1. Flatten the lock nut tab, and then remove the lock nut while holding the rear spline part of the drive pinion shaft using ST1 and ST2. Pull out the drive pinion collar.
| ST1 498937110 | HOLDER |
| ST2 499787700 | WRENCH |
| ST3 499787500 | ADAPTER |
2. Remove the O-ring.
3. Separate the rear roller bearing and outer race from the drive pinion shaft using a press.
|
(A) |
Outer race |
4. Separate the front roller bearing from the drive pinion shaft using a press and the ST.
| ST 498517000 | REPLACER |
|
(A) |
Front roller bearing |