NOTE:
The illustration shows a representing model. Perform the same procedures for the other models.
1. Install the master cylinder to the vehicle body, and connect the clutch pipe to the master cylinder.
NOTE:
Check that the pipe is routed properly.
Tightening torque:
T1: 15 N·m (1.5 kgf-m, 11.1 ft-lb)
T2: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
2. Connect the push rod of the master cylinder to the clutch pedal, and install the clevis pin and snap pin.
CAUTION:
Always use a new clevis pin.
NOTE:
Apply grease to the clevis pin.
|
(A) |
Clevis pin |
|
(B) |
Snap pin |
|
(C) |
Push rod |
3. After bleeding air from the clutch system, ensure that the clutch operates properly.
4. Install the air intake chamber. (Gasoline non-turbo model)
5. Install the intercooler.
• Gasoline turbo model
• Diesel turbo model