1. Remove the transmission under cover.
2. Clean the transmission exterior.
3. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.
4. Using the TORX® bit T70, tighten the transmission gear oil drain plug.
NOTE:
Use a new gasket.
Tightening torque:
44 N·m (4.5 kgf-m, 32.5 ft-lb) (Aluminum gasket silver)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (Copper gasket brown)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (Metal gasket black)
5. Remove the exhaust pipe (rear) and muffler. 
6. Remove the heat shield cover.
7. Remove the propeller shaft.
8. Using the ST, remove the oil seal.
| ST 398527700 | PULLER ASSY |
|
(A) |
Oil seal |
9. Using the ST, install the oil seal.
| ST 498057300 | INSTALLER |
10. Apply transmission gear oil to the oil seal lips.
11. Install the propeller shaft.
12. Install the heat shield cover.
13. Install the exhaust pipe (rear) and muffler.
14. Install the transmission under cover.
15. Pour in transmission gear oil and check the oil level.