MANUAL TRANSMISSION AND DIFFERENTIAL(6MT) > Front Differential Assembly

DISASSEMBLY

1. DIFFERENTIAL CASE ASSEMBLY

1. Loosen the twelve bolts and remove hypoid driven gear.

(A)

Hypoid driven gear

2. Drive out the straight pin from differential assembly toward hypoid driven gear side.

ST    899904100 REMOVER

3. Pull out the pinion shaft, and remove the differential bevel pinion, differential bevel gear and washer.

(A)

Pinion shaft

(B)

Differential bevel pinion

(C)

Differential bevel gear

(D)

Washer

4. Using the ST, remove the roller bearing.

ST    899524100 PULLER SET

2. SIDE RETAINER

1. Remove the O-ring.

2. Remove the oil seal.

NOTE:

• Remove using the flat tip screwdriver.

• Do not reuse the oil seal. Replace the oil seal with a new part.