1. Install the oil pump to bracket.
Tightening torque:
16 N·m (1.6 kgf-m, 11.8 ft-lb)
Tightening torque:
Non-turbo model
36 N·m (3.7 kgf-m, 26.6 ft-lb)
Turbo model
48 N·m (4.9 kgf-m, 35.4 ft-lb)
2. Attach the installation bolts of the power steering pump bracket.
Tightening torque:
3. After installing the oil pump, fill the oil pump with fluid while rotating the pulley by hand and bleed the air from the oil pump.
CAUTION:
Always fill the oil pump with the fluid to prevent abnormal noise and seizure of the oil pump.
4. Connect the pressure hose and suction hose.
Tightening torque:
Eye bolt
40 N·m (4.1 kgf-m, 29.5 ft-lb)
CAUTION:
Be careful when installing; If the hose is twisted it may come into contact with other parts.
• Non-turbo model
|
(1) |
Suction hose |
|
(2) |
Pressure hose |
• Turbo model
|
(1) |
Suction hose |
|
(2) |
Pressure hose |
5. Connect the connector to the power steering pump switch.
6. Install the V-belts (front side belt).
7. Connect the ground cable to battery.
8. Fill with the specified power steering fluid.
CAUTION:
Never start the engine before filling with fluid; otherwise the vane pump may become seized.