| CHECK HARNESS CONNECTOR BETWEEN EACH CONTROL MODULE AND DATA LINK CONNECTOR. |
|
1) Turn the ignition switch to OFF. 2) Disconnect the airbag control module, VDC&H/U, ECM and TCM. 3) Measure the resistance between data link connector and chassis ground. Connector & terminal (B40) No. 7 — Chassis ground: |
| QUESTION | |
|
Is the resistance 1 MΩ or more? | |
| Yes | No |
|
|
Repair the harness and connector between each control module and data link connector. (Replace the entire harness if repair is necessary for airbag harness.) |
