| CHECK AIRBAG REAR HARNESS (PRETENSIONER HARNESS RH). |
|
1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more. 2) Disconnect the airbag resistor from the connector (2N) of test harness N. 3) Disconnect connector (AB24) from side airbag module (RH). 4) Disconnect the connector (AB30) from lap seat belt pretensioner (RH). 5) Disconnect the connector (AB33) from curtain airbag module (RH). 6) Disconnect the connectors (AB6, AB17, and AB18) from airbag control module. 7) Connect the test harness AG connector (1AG) to the connectors (AB18, AB17, AB6). NOTE: For model without side airbag, connect test harness AH between the connectors (AB6, AB17, AB18) and (1AG). 8) Measure the resistance between connector (3AG) in the test harness AG and connector (2N) in the test harness N. Connector & terminal (3AG) No. 18 — (2N) No. 2: (3AG) No. 20 — (2N) No. 1: |
| QUESTION | |
|
Is the resistance less than 10 Ω? | |
| Yes | No |
|
|
Replace the airbag rear harness along with body harness. |
