CHECK AIRBAG REAR HARNESS (PRETENSIONER HARNESS LH).

1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more.

2) Disconnect the airbag resistor from the connector (2N) of test harness N.

3) Disconnect connector (AB19) from side airbag module (LH).

4) Disconnect the connector (AB31) from curtain airbag module (LH).

5) Disconnect the connectors (AB6, AB17, and AB18) from airbag control module.

6) Connect the connector (1AG) in the test harness AG to the connectors (AB6, AB17, and AB18).

NOTE:

For model without side airbag, connect test harness AH between the connectors (AB6, AB17, AB18) and (1AG).

7) Measure the resistance between connector (3AG) in the test harness AG and connector (2N) in the test harness N.

Connector & terminal

(3AG) No. 12 — (2N) No. 2:

(3AG) No. 10 — (2N) No. 1:

QUESTION
Is the resistance less than 10 Ω?
Yes	No
	Replace the airbag rear harness along with body harness.