| CHECK AIRBAG REAR HARNESS (CURTAIN AIRBAG MODULE HARNESS RH). |
|
1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more. 2) Disconnect the connector (AB26) from seat belt pretensioner (RH). 3) Disconnect connector (AB24) from side airbag module (RH). 4) Disconnect the connector (AB30) from lap seat belt pretensioner (RH). 5) Disconnect the airbag resistor from test harness N. 6) Disconnect the connectors (AB6, AB17, and AB18) from airbag control module. 7) Connect the connector (1AG) in the test harness AG to the connectors (AB6, AB17, and AB18). 8) Measure the resistance between connector (6AG) in the test harness AG and connector (2N) in the test harness N. Connector & terminal (6AG) No. 6 — (2N) No. 1: (6AG) No. 8 — (2N) No. 2: |
| QUESTION | |
|
Is the resistance less than 10 Ω? | |
| Yes | No |
|
|
Replace the airbag rear harness along with body harness. |
